1. Check out the Hot Deals section of the Marketplace forum to view and order an official Mossbergowners.com hat.

Pumping 590a1 directly after shot not possible - moddable?

Discussion in 'Mossberg 590 Pump Action' started by spofny, Nov 9, 2019.

  1. spofny

    spofny Copper BB

    Messages:
    6
    I find that pulling back on the forend of a loaded 590a1 provides a pretty stable platform as well as stopping the forend from rattling. The problem when doing that is that the forend is blocked from pumping after firing until you stop holding it rearward. Is that behaviour moddable? If it is, is it advisable to do so?
  2. nitesite

    nitesite Sheepdog Moderator "Philanthropist"

    Messages:
    5,618
    Welcome to the forum.

    You must be pulling back extremely hard while the round ignites.

    Don't try to mod it. Not necessary. Just learn to shoot a pump shotgun correctly.
    fellmann likes this.
  3. John A.

    John A. I'm "THAT" guy Staff Member Global Moderator Moderator

    Messages:
    14,497
    I have fired some shotguns where you can hold light pressure rearward when you fire a round and it helps to make pumping the action a little faster.

    The Winchester 1300 speedpump is a prime example of that.

    But, the bolt is different on the Winchester. So, you can't really do that with a Mossberg.
    fellmann likes this.
  4. spofny

    spofny Copper BB

    Messages:
    6
    Alright, thanks guys. :)

Share This Page