1. Thank you Mossberg Owners for making us the greatest Gun forum on the planet.

Pusher Assembly broken pin

Discussion in 'Mossberg 930 Autoloader' started by dude, Oct 28, 2018.

  1. dude

    dude .22LR Supporter

    Messages:
    21
    another issue with my jm pro. looks like i ran into another common issue with my jmpro

    Attached Files:

  2. Yanger

    Yanger Copper BB

    Messages:
    7
    I had to sand my pusher assembly down to get it sliding smooth over the barrel
    I'm forseeing that to be a weak spot later on
  3. dude

    dude .22LR Supporter

    Messages:
    21
    I did not find any excessive wear or galling on Pin.

    I think Mossberg, just miscalculated Pin diameter.

    As you can see in the attached picture, they went from large diameter to smaller and smaller.

    Attached Files:

  4. Greg B

    Greg B .410

    Messages:
    98
    That looks ridiculously short for the job it does.
    When I made my own pusher assy, I made the pins have over an inch of engagement into the pusher body.
    I'm sure Mossberg will replace it. But, dang.

Share This Page