1. Check out the Hot Deals section of the Marketplace forum to view and order an official Mossbergowners.com hat.

stiff cycle after changing out foreend on A590

Discussion in 'Firearm Maintenance, Safety And Troubleshooting' started by Jimmy Cmpit, May 6, 2019.

  1. Jimmy Cmpit

    Jimmy Cmpit Copper BB

    Messages:
    1
    I replaced the aftermarket forearm on my A590 with the OEM Slide and nut from Mossberg

    Action Slide, 12 Gauge, 7 3/4



    1

    Action Slide Nut, 12 Gauge, Blued, For 7 3/4" Slide Assembly

    so I could add an Insight Tech Forearm, Synthetic, 12 Gauge (Fits 7 3/4" Action Slide)

    Since taking everything down and spraying with Winchester Gun lube and patting the residue off the gun feels a lot tighter when I cycle it. It’s not stopping at some point, it doesn’t feel like it’s catching anywhere it’s just tighter than normal. I’m concerned before I put live ammo in there, does anyone have suggestions? Thanks!
    meanstreak likes this.
  2. John A.

    John A. I'm "THAT" guy Staff Member Global Moderator Moderator

    Messages:
    14,518
    So the forend is just free floating?

    Can you look at the ejection port and tell if the bolt is sliding back and forth when you move the forend?

    Winchester gun lube does usually help reduce friction and make things slicker.
    ripjack13 and meanstreak like this.

Share This Page