1. Check out the Hot Deals section of the Marketplace forum to order an official Mossbergowners.com hat.

Stock comb riser

Discussion in 'Holographic/Red Dot Sights' started by Blindhawg1, Oct 10, 2017.

  1. Blindhawg1

    Blindhawg1 Lurker

    I just added a Truglo Sight onto an Aimtech AMS-3 Realtree camo saddle to a Maverick for turkey hunting. The problem is that I have to lift my head about an inch off the stock to get a sight picture. Any recomrndations for a stock riser? Screenshot_2017-10-10-17-35-23.png [AT TACH=full]16751[/ATTACH]

    Attached Files:

  2. old mossy

    old mossy Global Moderator Staff Member Global Moderator Moderator

    Do a Google search on comb risers. They sell kits that have a bunch of different thickness pads you can swap around. Holds onto stock with an elastic sleeve.
  3. nitesite

    nitesite Average Guy Moderator "Philanthropist"

    You could go ugly and cheap and duct tape some pipe insulating foam tubing over the buttstock until you find the best riser height, then maybe look for a commercially-made riser to match the height. Two layers ought to get you close.

    Or just keep the temporary set up for the hunting season and decide later what you will do.
  4. Retired1

    Retired1 Lurker

    I have one on my 835 Turkey Thug (I have a similar one on my SA-20 Turkey Thug). It goes on and off quickly and easily. It stays in place due to a slight 'tacky' underside. I got it on eBay several years ago. It has a 1" rise in front and a 1-1/2" rise in the rear. It puts my eye perfectly centered with the red dot in the TruGlo sight.

    Last edited: Oct 11, 2017
    TJ Johnson likes this.

Share This Page