It wouldn't cycle any of the shells reliably. Most were better that trying to cycle the snap cap but not enough to trust on a home defense gun. I'm guessing that the brass offered a more slippery surface than the snap cap but still didn't cycle every time.
I've been looking at the trigger springs from them... if I order for my 500s, I'll order for my 935 & 870 too. I don't have a problem with the triggers so I'm not sure I need them but they are on my radar & I'm looking for further reviews.
This particular shotgun has some (cough cough) questionable "etching" that looks like it was done by a 12yr old on the left side of the receiver... a symbol that I would not want on any of my firearms :doh: so there's going to be some sanding and primer to try to fill the affected area.
I bought a cartridge stop from Mossberg but figured I'd try my hand at modifying the existing one since, if I screw it up, I have another one on the way. I used a Dremel to take off material on the hooked end, lightly going over the flat face of the stop and reinstalling to test retention &...
I googled the symptoms my Mossberg 500A was having & this site had several posts on the problem(s) and I ended up hanging around like a bad fart because of the knowledge & quick responses.
So, let me start by saying that I've never been much of a deer hunter, birds have always been my game of choice but my dad is wanting me to get out in the woods to go deer hunting with him. I can borrow an 11-87 (that is really picky about ammo) to use but also found a good deal on a 935 slug...
I feel like the problem lies in the relationship between the left action bar & the corresponding cartridge stop. When the action is cycled open all the way, the beveled edge of the left action bar isn't moving the beveled edge of the cartridge stop enough. It's as if there's too much material...