• Mossberg Owners is in the process of upgrading the software. Please bear with us while we transition to the new look and new upgraded software.

OR3GUN Follower Comparison Pictures

OR3GUN

Sponsor
Sponsor
It can be difficult to tell the size and profile of a follower without others to compare to, so we did an old fashioned line-up for you:

OR3GUN-Follower-Comparison-Side.jpg


From left to right: Nordic, OR3GUN, Dave's, GG&G, Mossberg V1, Mossberg V2

As you can see, our Enhanced Competition Follower was designed to fill a gap between the shorter OEM style followers and the greatly extended versions like those of Nordic, RCI and others. The OR3GUN follower peeks out a bit more than others when the gun is empty and provides good contrast against typical shot shells at 'show clear'.

ECF-Show-Clear-Angle.jpg


Incidentally, since it was designed from start to finish in Oregon, it also has the largest drain hole, as you can see in this view from the top.


OR3GUN-Follower-Comparison-Top.jpg


All of the edges of the OR3GUN follower have been rounded, rather than chamfered, which helps to prolong the life of the anodizing and teflon seal. It was designed to have a good balance of features, but stops short of simply hiding major flaws in tube alignment and transitions. We also made sure that the interior of the follower would accommodate the widest range of factory and aftermarket springs.

We have introduced the ECF at just under $20, so the art of finding the perfect follower for finicky tube/spring length combinations won't eat up too much of your money if it doesn't help your 930 swallow that extra round you were hoping would fit. It has been shown to still allow FULL capacity in the 24" JM Pro with factory magazine spring.

Thanks!

William

http://www.OR3GUN.com
 
Ordered the follower and Multi Use MST on Monday. My order shipped Tuesday and arrived Thursday.

High quality pieces.

Great job OR3GON!
 
Back
Top