The red dot under the tang safety on my 500A has worn off. When I contacted Mossberg about replacing it, they said the red dot was painted on. I'm not sure this is completely the case. When I look down the hole were the red dot should be (the hole is about 1/8" in diameter), it is recessed about 1/8" deep and there is a pin in the center of the hole. It almost looks as though something goes over the pin that might have been painted red.
Does anyone have any experience with replacing the red dot under the tang safety? Any assistance or ideas will be greatly appreciated.
Does anyone have any experience with replacing the red dot under the tang safety? Any assistance or ideas will be greatly appreciated.