I'm gaging interest in making rear M16 front sight posts and aluminum slip on flash hider for the 715t.
I make these for the S&W 1522 and now that the 715t has gained popularity, I am wondering if there would be enough interest in doing this.
I would imagine the handguard to be shortened and an end cap needed also, they the sight post would keep everything tight.
The flash hider would be a neat slip fit and attach with an 8-32 cup point set screw, this has been more that sufficient for the 1522.
I made one (hider) back in 2011 for these but very little interest...
Please reply with your opinions.
Thanks
Pic is of the parts made for 1522
I make these for the S&W 1522 and now that the 715t has gained popularity, I am wondering if there would be enough interest in doing this.
I would imagine the handguard to be shortened and an end cap needed also, they the sight post would keep everything tight.
The flash hider would be a neat slip fit and attach with an 8-32 cup point set screw, this has been more that sufficient for the 1522.
I made one (hider) back in 2011 for these but very little interest...
Please reply with your opinions.
Thanks
Pic is of the parts made for 1522