1. Check out the Hot Deals section of the Marketplace forum to order an official Mossbergowners.com hat.

Mossberg 535 increase length of pull

Discussion in 'Mossberg 535 ATS Pump Action' started by Oddjob, Nov 17, 2015.

  1. Oddjob

    Oddjob Copper BB

    Messages:
    6
    Hello, I just purchased a new mossberg 535 camo plastic stock to use as my sneak boat in the salt marsh . I have several other high end shotguns that I have had fitted and I had to add all the stock spacers to increase length of pull to 15 inches , due to the fact I am 6"5. Does mossberg or anybody else make bigger// longer recoil pads or make stock spacers to add more length of pull . I have the plastic camo stock , if it was wood I would have no problem to get a custom ground one . ---Help ---
  2. Bobster

    Bobster .30-06 Supporter

    Messages:
    2,157
    Perhaps you could craft a 1" spacer and use longer screws. I'm pretty sure stock LOP is 14". Alternately, you could get a Limbsaver or similar and slide it on. I'm sure someone will be along to add more pertinent info...

    Welcome Aboard! :)
    Rossignol likes this.
  3. Oddjob

    Oddjob Copper BB

    Messages:
    6
    So far I filled the hallow part of the stock with the spray foam and placed a 3 once sinker in the stock for some added weight. I made 1/4 inch plastic spacers to go where the screw holes, can't go any more because their will be a space/gap between stock and recoil pad .

    Does anybody know if the limbsaver is any longer/thick than the stock recoil pad ??
  4. Rossignol

    Rossignol The Original Sheriff Staff Member Global Moderator Moderator Sponsor

    Messages:
    12,758
    I've heard from others here the Limbsaver adds a little. I wanna say about a half inch.
  5. Oddjob

    Oddjob Copper BB

    Messages:
    6
    If the limbsaver adds 1/2 then I will be good to go , I have already add 1/4 . I can live with that
  6. Oddjob

    Oddjob Copper BB

    Messages:
    6
    Does anybody know which limbsaver will fit a 535 camo plastic stock , I think it is limbsaver part #10201. Just trying to confirm before I order I

Share This Page