Dirtweed
.22LR
Hey Guys,
OK I'm not that versed in tearing down Mossberg's like I am an 1100, but when I put it back together after I had it dipped in camo when I load a shell and close the bolt and the shotgun is on it's side the bolt will not move all the way forward and it will give me a light strike on the pin and not fire the round. If I move the handle back a bit and then forward the gun will fire. Now after I load it and if I close the bolt with it held in the orientation I would to fire it the bolt closes all the way and it will fire.
I've torn it down a couple of times and made sure all was good inside and it seemed fine, but it acts the same...I've also tried with the original bolt handle and with the JM-like handle I bought.
Thanks
Darrin
OK I'm not that versed in tearing down Mossberg's like I am an 1100, but when I put it back together after I had it dipped in camo when I load a shell and close the bolt and the shotgun is on it's side the bolt will not move all the way forward and it will give me a light strike on the pin and not fire the round. If I move the handle back a bit and then forward the gun will fire. Now after I load it and if I close the bolt with it held in the orientation I would to fire it the bolt closes all the way and it will fire.
I've torn it down a couple of times and made sure all was good inside and it seemed fine, but it acts the same...I've also tried with the original bolt handle and with the JM-like handle I bought.
Thanks
Darrin
Last edited: