Got this for bulk loading and it seems to work real well. I can get about 4-500 through this trimmer in about an hour at a casual pace.
So far no burr to speak of has developed so no need to deburr but as the cutter dulls I anticipate the reappearance of a burr.
I wouldn't suggest this over a normal trimmer fir normal low volume reloading however if you have calibers you shoot in bulk and want nice uniform lengths fast the WFT is a great addition to your bench
It has two set screws to adjust the cutter. The cutter has aggressive flutes to evacuate chips up to the big hole and fling them out of the tool
They put a bearing in the end that has a machined center to accept the cartridge . It is like a case guage in a way and it references the cut from the shoulder of the case so it important that you run the cases through YOUR sizing die so the cut remains consistent
Low drill RPM is better than high as brass will not cut that fast because its soft and it will probably just roll a big burr on the case mouth
It is built super well and this is a big time saver for a bulk reloading session
So far no burr to speak of has developed so no need to deburr but as the cutter dulls I anticipate the reappearance of a burr.
I wouldn't suggest this over a normal trimmer fir normal low volume reloading however if you have calibers you shoot in bulk and want nice uniform lengths fast the WFT is a great addition to your bench
It has two set screws to adjust the cutter. The cutter has aggressive flutes to evacuate chips up to the big hole and fling them out of the tool
They put a bearing in the end that has a machined center to accept the cartridge . It is like a case guage in a way and it references the cut from the shoulder of the case so it important that you run the cases through YOUR sizing die so the cut remains consistent
Low drill RPM is better than high as brass will not cut that fast because its soft and it will probably just roll a big burr on the case mouth
It is built super well and this is a big time saver for a bulk reloading session