Very nice luckybaer!
Welcome aboard...
Welcome aboard...
That mount is made to work with the heat shield. The bolts on the mount will replace the two heat shield bolts…….it can be run on the tube independent of the heat shield as well. This is it being used with the HS, I don’t have the plastic but I would use it if I had it.Horsepow3r said:
saddlebagpix said:Hello everyone, I picked up a Mod 500CG 20ga. as a set with a 28" vent rib and 24" smoothbore slug barrel -w- sights. I'm not seeing this particular combination ANYWHERE on the web??? The reciever is solidly marked "500CG". Does anyone have any history on these or even a value? Metal is 90-95% no pits, scatches or rust, just minor scuffs (the underside by the model# stampimg is the worst), bores are brite, wood is the same condition or better.
Much thanks in advance! I look forward to getting to the range this weekend and putting it though it's paces.
Scott in Tampa
LAZY EYED SNIPER said:saddlebagpix said:Hello everyone, I picked up a Mod 500CG 20ga. as a set with a 28" vent rib and 24" smoothbore slug barrel -w- sights. I'm not seeing this particular combination ANYWHERE on the web??? The reciever is solidly marked "500CG". Does anyone have any history on these or even a value? Metal is 90-95% no pits, scatches or rust, just minor scuffs (the underside by the model# stampimg is the worst), bores are brite, wood is the same condition or better.
Much thanks in advance! I look forward to getting to the range this weekend and putting it though it's paces.
Scott in Tampa
Mossberg model IDs have always been a bit hard to figure out. Even current production is scattered around between Mossberg's own models as shown on their site/catalog and the countless vendor and distributor exclusive model numbers. We'll do some diggin and see what we can figure out, but don't be surprised if we all come up scratching our heads.
Oh, and welcome aboard...
Sn3aKyGuY said:How do you like that black powder setup on the 500?